ASM wire bonder is a common equipment, ASM wire bonder for automatic welding, it is necessary to debug ASM wire bonder program, according to the needs of their own solder products, solder machine programming. So what are the welding programming methods of ASM wire bonder?

1. prepare the welding sample

Prepare samples to be welded and secure on the work platform of ASM wire welding machine.

2. analyze welding samples

For the same welding sample, there may be different welding plates and different welding methods. According to the requirements of relevant welding process, the welding samples shall be analyzed to determine whether to use spot welding or pull welding, determine how many groups of welding parameters (wk parameters) are used, and which group of welding parameters (wk parameters) are used for each welding point.

3. adjust the position of the soldering iron group and select the appropriate soldering head.

Set the temperature of welding controller to 50 ℃, and adjust the tin feeder to non tin feeding state. Different welding samples may require the soldering head to work at a certain angle and slope. The position of the soldering iron group should be adjusted appropriately according to the relevant welding process requirements. Different welding samples also need to use different size, different shape, different power soldering head, so we should also choose suitable soldering head according to the relevant welding process requirements.

4. adjust the installation procedure of solder machine

ASM wire welding machine starts normally. After returning to zero, the system will automatically load the default operating program, or load other programs, or establish a new program. If the program is not empty, you can press and hold the Del key program to delete the null.

5. select teaching mode

Press mode to switch the working mode to teaching mode. There are two situations: manual mode and micro mode.

Press and hold vel key to switch the speed of manual movement, which is manual speed and slow speed is micro speed. When the speed is manual speed, manual will be displayed in the lower right corner of the page, and when the speed is micro speed, the micro motion will be displayed in the lower right corner of the page. If the manual and fretting speeds are not in accordance with the requirements, too fast or too slow in the following steps, the manual and inching speeds need to be reset.

6. ASM wire welding machine return to zero

Press and hold the home key to return the machine to zero to ensure the accurate coordinate of the solder joint.

7. coordinate of teaching welding point.