The molding system programmed by ASM IC packaging equipment can be flexibly used for single-roll or double-roll molding, which can prevent the plasticized items from being damaged and ensure better plastic packaging quality. Then what matters should be paid attention to when using ASM IC packaging equipment What?

1. The influence of the environment on the plastic packaging: the preheating and stabilizing time of the plastic packaging machine is affected by the environmental temperature. When the environmental temperature is high, the plastic packaging temperature can balance and stabilize quickly. . Don't start plastic packaging as soon as the temperature display reaches the plastic sealing temperature after starting the machine, because at this time the rubber roller of the plastic sealing machine has not been matured and stabilized, but the local temperature near the temperature measuring point has reached the plastic sealing temperature. Generally speaking, the warm-up stabilization time should not be shorter than 20 minutes. The design index of the working environment of the laminator is 5~40℃, the relative humidity is not more than 80%, and there is no corrosive gas. Therefore, the laminator can work normally under normal seasons and weather conditions, and the plastic sealing effect will not be affected.

2. The impact of rubber roller hardness on plastic sealing The rubber roller hardness of the plastic sealing machine is 50 degrees Shore. If the rubber roller becomes hard or cracked due to aging or other reasons, the quality of the plastic seal will be affected, and the plastic seal of the over-plastic certificate will not be firmly sealed, and the rubber roller needs to be replaced in time.

　　3. Plastic package quality inspection. The plastic packaged document should be transparent and flat, and the plastic sleeve and card core should be firmly sealed as a whole. There is no "sufficiency" in the interlayer, no "fuzzy white printing", no oil stains, impurities and other undesirable phenomena. Several common abnormal phenomena and the reasons for the judgment, such as partial unsealing, should be considered as the plastic sealing temperature is too low. If the document is deformed and wrinkled after the plastic sealing, it should be considered as the plastic sealing temperature is too high or the pressure is too large. Air bubbles or fuzzy white impressions should be considered as inappropriate molding temperature. If the adhesive overflows during the molding process, it should be considered that the molding temperature is too high or the pressure is too high.

　　 The above are some of the matters that should be paid attention to when using ASM IC packaging equipment. In addition to the correct operation and use of the laminator, care and maintenance of the laminator should also be paid attention to. Bestsun Electronic Technology Co., Ltd. mainly provides ASM Pacific Technology Advanced Pacific (Hong Kong) Co., Ltd. welding and packaging equipment, ASM equipment and technology are in a priority position in the world. The company is equipped with a professional senior engineer and after-sales service team, with strong strength and excellent management service experience, to design advanced and reasonable humanized process for customers to help customers improve process and product quality.